Fresh refurbish. Case Sandblasted. Bearings and clutches replaced as needed. VERY LITTLE gear wear! NE……..$1175.00…….Plus Shipping
Month: September 2022
496.62 CUBIC INCH 409 / STANDARD BORE / 4 BOLT MAINS
ES…….$4550.00 —–Can Ship if required – Deliver within a 75 mile radius of 06437 Our most recent parts acquisition came from a long time drag racer (still racing at 80). He had been collecting, building, selling and racing 409’s since 1968. The engine being offered here is one that he had a hand in. Although…
EARLY 1962 409 / 690 HEADS (K661) – APPEAR READY TO GO – SOLD, ….being used on a K2561 block
Matched set of 409 / 690 heads with casting date of K661 for both heads. These heads were not pinned, but have screw in rocker arm studs (factory?) These appear to have valve work done and come with the springs. Look to have been prepped, but never mounted on engine. Nice set of heads. ES…
1963 409 DUEL QUAD AIR CLEANER #2..SOLD
These air cleaners are very good driver quality +. There are no dents or bumps. Both show repairs that images show. NONE VISIBLE WHEN MOUNTED ON CARBS. Some chrome loss in the lid grooves and around snorkels. Some diffuse oxidation throughout and the typical scratching on surface of lid. I did the first polish –…
1963 409 DUEL QUAD AIR CLEANER #1… SOLD
These air cleaners are very good driver quality +. There are no dents or bumps. Both show repairs that images show. NONE VISIBLE WHEN MOUNTED ON CARBS. Some chrome loss in the lid grooves and around snorkels. Some diffuse oxidation throughout and the typical scratching on surface of lid. I did the first polish –…
VERY NICE 409 RADIATOR. CLEAN INSIDE AND OUT. – SOLD
appears to have been refurbished years ago. Getting hard to find. – ES – $400
814 BLOCK 409/425 HP ENGINE – SOLD
Block has been decked. Crane Cam, lifters, pushrods and roller rocker arms. .30 Over. Matching Carbs 3361 & 3362 with matching AD2 dates. – ES $6,500.00
1962 409/409 BARN FIND. COMPLETE ENGINE – SOLD !!
Taken out of car mid 60’s. Never put back in car. However, we took a chance after a thorough inspection it was started on the storage stand! Fired up and ran like a top! First time in 60 years!! $12,000
1963 CHEVY IMPALA, ETC. FRONT FENDERS (DYNACORN) BODY WORKED & PAINTED
THESE WERE MADE READY TO GO ON MY Z-11 when I finally found some aluminum fenders. These were purchased and painted about 7 years ago. Super straight and lines are as good as they get! Shown fitted on my car. ES – $600.00 for the pair. Shipping is a killer anymore, so I will deliver…
USED CHEVY Z-BAR FROM X-FRAME
Used , but very clean bar. Has slight bend (purpose bend, vice marks), but very usable as is or you can straighten if desired. – ES – $60.00 plus shipping
1963 TAIL LAMP GASKET SET. MADE IN USA
NOS OLDER SET – $10.00 shipped – Made in USA
348-409 OIL FILL TUBES
THESE TUBES HAVE BEEN ULTRASONICALLY CLEANED. -ES- CAR TUBES ARE $22.00 EACH, TRUCK IS $30.00 Plus Shipping Ran out of paint, so OEM base metal shows.
VERY NICE 1963 / 1964 HP 409 EXHAUST MANIFOLDS – THIS SET IS SOLD
VERY NICE CASTINGS WITH NO CRACKS OR ISSUES. Casting numbers and lettering is weak, but what you normally find today. – ES – $1700.00 Shipped
1964-1969 CLUTCH FORK / BELL HOUSING BOOT RUBBER BOOT
ES $27.50 SHIPPEN IN US
1962-64 Z-BAR NOS REPRODUCTION
ES – $75.00 SHIPPING
NEW ARP SCREW IN ROCKER ARM STUDS
ES – $59.00 PLUS SHIPPING
NOS VINTAGE CAM TECHNIQUES SOLID LIFTER 349 / 409 CAMSHAFT , FLAT TAPPET
ES – $200.00 – PLUS SHIPPING
VINTAGE FEL PRO 409 REAR MAIN SEALS
ES – $20.00 / SHIPPED
1958-1964 ENGINE MOUNT BRACKETS
OLDER REPRODUCTION ENGINE MOUNT BRACKETS. – ES – $50.00 Plus Shipping
EXCELLENT 1963 / 64 HP 409 EXHAUST MANIFOLDS
Much better than usually found! Very nice castings with clear, legible casting codes and dates. No problems. Hard to find this nice! – ES – $1900.00 – Plus Shipping
MID 61 DATED BORG WARNER T-10. PERFECT FOR AN EARLY 1962 BUILD.
Virtually all components are 8-61 dated with just days apart! This transmission has been refurbished by Ray Whitney (1962 409 Wagon H/S & Many Wally’s won). Transmission showed very little use, but he did replace the bushings and thoroughly cleaned. As New – ES – $1550.00
VINTAGE 409 VENOLIA RACING PISTONS (NOS)
IF YOU ARE LOOKING FOR A SET OF RACING PISTONS, THIS IS IT! This is for a full ordered set of 10 pistons (typical for a race engine). If you are waiting for back ordered pistons………. ES – $1025.00 Plus Shipping
MINTY 1965 409 EXHAUST MANIFOLDS
These are the best I’ve seen. No problems anywhere & somewhat hard to find. A must for a 65 Chevy 409 build – ES – $2000.00 Plus Shipping
REFURBISHED & BUSHED BB CHEVY TRUCK RODS
ES – $425 – Plus Shipping
REFURBISHED & BUSHED BB CHEVY RODS
Ready to go into your 409 stroker – $400 – ES – Plus Shipping
MINTY, CLEAN 1963 POSI CASE
Very nice case with NO issues – ES – $525.00 – Plus shipping
CLOYES CAM GEAR DRIVE (NOS?)
Very nice vintage Cloyes geardrive. Shows little to no wear. Looks complete? ES- $100 Plus Shipping
1963 BISCAYNE / BELAIR REAR DECK HARNESS – ES – $53.00 Plus Shipping
PCV ADAPTORS (SMALL BLOCK) – 409 USE
An easy solution for the 63 press fit PCV tube on the rear intake. They are a pain! ES – $25.00 ea. Shipped
1963-64 (EXCEPT 63 409)LOWER CLUTCH ROD
Very nice in package reproduction rod – ES – $75.00 – Plus shipping
1963 / 1964 (others?) CLUTCH PEDAL LINKAGE, COMPLETE, OLDER AFTERMARKET
New in the package. Older Repo, but appears to be very nice quality – ES – $ 60.00 Plus Shipping
1964-1965 409 DRAFT TUBE
I’ve not seen this one before. This particular item bolts to the back of the head and not the intake manifold bolt. (? Corvette? ) Original OEM – $85.00 Plus Shipping
1964 / 65 409 DRAFT TUBE
HARD TO FIND ORIGINAL – Bolts to intake manifold bolt. Bolt included – ES – $85.00 Plus Shipping
1958 / 1962 – 348 / 409 DRAFT TUBE
Very nice – ES- $95.00 Plus Shipping
TIMING CHAIN COVER, HIGH PERFORMANCE 409 – 1 SOLD – HAVE MORE – INQUIRE
OEM – ES – $75.00 Plus shipping
MINTY 348 / 409 TIMING CHAIN COVER
Very nice TC cover. – ES – $70.00 Plus Shipping
409 WINDAGE TRAY (USED) – SOLD
Taken off engine – cleaned in sealed plastic – ES —–$39.00 Plus Shipping
1963 ALUMINUM Z-11 FAN SHROUD (Show Cars)
Taken off my Z-11. Purchased from Show Cars in 2018 or so. Had it glass beaded and sealed with high temp clear satin. …………NE ………$500 Plus shipping